Opto-Isolated 4 Channel Relay Board

Opto-Isolated 4 Channel Relay Board

Please note: Large Quantities may have a longer lead time. Please email for details:terry@yourduino.com.

See more details, applications on our WIKI here:

With high-current relays, AC250V 10A ; DC30V 10A    NOTE: Each relay draws about .08A (80ma) so about 4 relays are the maximum you should run from the Arduino +5V supply.  (Running from USB it may be less).  More than 2 relays: we recommend you use a separate 5V supply for the relays.

Dimensions here: http://arduinoinfo.mywikis.net/wiki/RelayDimensions

NOTES: If you want complete optical isolation, connect "Vcc" to Arduino +5 volts but do NOT connect Arduino Ground.  Remove the Vcc to JD-Vcc jumper. Connect a separate +5 supply to "JD-Vcc" and board Gnd. This will supply power to the transistor drivers and relay coils. 

If relay isolation is enough for your application, connect Arduino +5 and Gnd, and leave Vcc to JD-Vcc jumper in place.

NOTE: It is sometimes possible to use these relay boards with 3.3V signals, IF the JD-VCC(RelayPower) is provided from a +5V supply and the VCC to JD-VCC jumper is removed. . That 5V relay supply could be totally isolated from the 3.3V device, or have a common ground IF opto-isolation is not needed.  If used with isolated 3.3V signals, VCC (To the input of the opto-isolator, next to the IN pins) should be connected to the 3.3V device's +3.3V supply. NOTE: Some RaspberryPi users have found that some relays are reliable and others do not actuate sometimes. It may be necessary to change the value of R1 from 1000 ohms to something like 220 ohms, or supply +5V to the VCC connection.

NOTE: The digital inputs from Arduino are Active LOW: The relay actuates and an LED lights whe the input pin is LOW, and turns off on HIGH. See the Wiki article for how-to assure relays do not activate at power-on time.

Schematic Diagram: HERE   and HERE

Please Read This Electrical Safety / Disclaimer page before using the relay board in this product.